Concrete Culvert Pipe Mold

Concrete culvert pipe mold is used to precast the concrete culvert pipe, the welding section for Cylinder, hooped, longitudinal reinforcement, flange, run laps is neat and smooth. concrete pipe mold w

Pipe Diameter : 300-2400mm
Pipe Length : 1-4m
Daily Output : 20-60pcs
Concrete Mix : C30

Concrete culvert pipe mold is used to precast the concrete culvert pipe, the welding section for Cylinder, hooped, longitudinal reinforcement, flange, run laps is neat and smooth. concrete pipe mold will be ensured with quality by careful inspection before delivery, welding crack is not allowed and inner wall must be smooth; Daubing engine oil on the inner mould  to prevent the mould wall be rust in transport.


Concrete pipe mold is composed of steel plate and steel, it is not easy to deformation with good stiffness. The mold will be hanged into suspension roller machine after daubing isolation agent, check the stability of the steel cage structure and if it is with sundry before put into the mold, Installing mold, Mold connection is hinged by bolts and nuts.


Concrete pipe mold need a higher stiffness, spun collars pipe can not store slurry, the weld section for cylinder, hooped, longitudinal reinforcement must be strong; it is needed to daub oil on inner mold to curing and inspect the mould, once find the mould deformation, It needs to be repaired immediately. Check if the size and concrete protective layer conform to the standard, if conformed ,then hang the mold in to the roller of machine.


Accurate size is one of important factor for quality, as well as the detail design for joint and retaining ring. The concrete pipe mold we produced use single slit mould, it is convenient to operate and not easy to deformation compared with double slit mold. The inner diameter for retaining ring is bigger 3mm〜5mm than the rule size according to the technology and pipe size requires. The mold cylinder should avoid to connect the steel plates on the longitudinal to prevent the mold deformation after welded which will impact the straight of the pipe.


Hanging the plug ring into mold slot in turn, lifting the two parts of mold to the area for closing mould with crane, then put the steel cage into one of the part. Adjust the position and steel wire protective layer, finally hang another part of mold merge with the previous one, check and adjust the steel cage, tighten the bolts. Hang the concrete pipe mold slowly to the main roller of the machine, closed the frame and  plug the fixed pin, Put the mold into the main roller of the machine, remove the hook and rope, and remove crane. Thus the work of lifting steel mould finished, then prepare to make pipe process.


TAG:   Concrete Pipe Mold
NumberModelJointBarrel / mmLongitudinal bar / mmReinforcement Bar / mm
ThicknessThicknessWidthQuantityThicknessWidthQuantity
1PG300-2000
Flush Joint
585028504
2Spigot Socket
3PG400-2000Flush Joint
4Spigot Socket
5PG500-2000
Flush Joint586028604
6Spigot Socket686028604
7PG600-2000
Flush Joint686048604
8Spigot Socket
9PG800-2000
Flush Joint61080610804
10Spigot Socket
11PG1000-2000
Flush Joint61080810804
12Spigot Socket
13PG1200-2000
Flush Joint612901012904
14Spigot Socket
15PG1500-2000Flush Joint81212012121204
16Spigot Socket

TAG:   Concrete Pipe Mold

Recommend